Cartwright Professional Assessment Tool
Jump Measurement Toolkit
Estimate flight-phase jump height from flight time or vertical take-off velocity, and keep the different jump measures distinct.
Free to use · No account required · Nothing you enter is stored or sent anywhere
Cartwright Fitness · Professional tools
Estimate flight-phase jump height from flight time or vertical take-off velocity, and keep the different jump measures distinct.
Choose your inputs
Worked example
A flight time of 500 ms is 0.500 s. Estimated rise after take-off is 9.81 × 0.500² ÷ 8 = 0.3065625 m, or 30.66 cm. The corresponding estimated take-off velocity is 9.81 × 0.500 ÷ 2 = 2.4525 m/s.
Choose the right jump measure
Flight time starts at take-off and ends at landing. The ballistic calculation assumes negligible air resistance and equal centre-of-mass height at those two events. Different leg or landing positions can break that assumption.
When measured vertical take-off velocity is available, height = velocity² ÷ (2 × 9.81). Both calculations describe the rise after take-off. They are different from fingertip jump-and-reach distance and from a direct measure of power.
What to record for a repeatable test
- Jump type: squat jump, countermovement jump or rebound/drop jump.
- Arm action, instructions, warm-up and trial-selection rule.
- Device, sampling or frame rate, event detection and calculation method.
- Flight time or take-off velocity in the original units.
- For drop jumps: drop height and ground contact time.
Use the RSI calculator for height divided by contact time or time to take-off. Use the squat-jump reference calculator only when its protocol and population fit.
Sources and method
Assumptions and uncertainty
Ballistic height from flight time uses h = 9.81 × t² ÷ 8 (t in seconds). From take-off velocity: h = v² ÷ (2 × 9.81). Worked example: 500 ms → 30.66 cm and 2.4525 m/s.
Uncertainty: estimates assume equal centre-of-mass height at take-off and landing. Arm swing, tuck, or soft landings can bias flight-time height. Device sampling and event detection also matter. Label the jump type and calculation method on every report.
FAQs
What does the jump measurement toolkit calculate?
It estimates flight-phase jump height from flight time (h = g·t²/8) or from vertical take-off velocity (h = v²/(2g)), with g = 9.81 m/s².
Is flight-time height the same as jump-and-reach?
No. Flight-time and take-off-velocity estimates describe the rise of the centre of mass after take-off. Fingertip jump-and-reach distance is a different measure.
What assumptions matter?
Negligible air resistance and equal centre-of-mass height at take-off and landing. Different take-off vs landing postures can break that assumption.
Does this calculate RSI or power?
No. Use the RSI calculator for height ÷ contact time. This tool does not estimate mechanical power.
Is any participant data stored?
No.
Page owner: Cartwright Fitness · Methodology last reviewed: November 2026 · Tool version: 1.1 (grip-family shell; CFMath jump equations unchanged)
